Power on the system
1. If an LVDS flat panel is attached and requires an external power supply, power it up before
2. Plug in the power supply. The system should automatically power on the first time the
Check the BIOS settings
It is a good idea to check the BIOS settings before installing the operating system to make sure
the default settings are appropriate for devices you have installed. To enter the BIOS Setup
utility, press F2 during system boot.
After installing the operating system, you may also want to change the boot order in the BIOS,
so that the hard disk is checked first.
If problems are encountered during boot up, error messages may be displayed on the monitor.
You can also use a POST card to determine where the system encountered problems.
Online help is provided in the BIOS setup to explain options. For further information, refer to the
Product Manual.
powering up the system. Otherwise, the panel's power supply will be provided by the
CR100 carrier board via the backlight control connector.
power supply is connected, but you may have to press the power button on the chassis (if
connected) or the power button on the CR100 carrier board.
Power on the system
4
29