Related Manuals for RadiSys PROMENTUM ATCA-4500
Summary of Contents for RadiSys PROMENTUM ATCA-4500
- Page 1 (217) 352-9330 | Click HERE Find the RadiSys ATCA-4500 at our website:...
-
Page 2: Before You Begin
OS for the initial installation. The Promentum software distribution CD-ROM image. Download the image at www.radisys.com/downloads. A console serial cable (RJ-45 to DE9-S, RadiSys order code ATCA-SERIAL-CBL). The same cable is included in shipments of the ATCA-2210 SCM. -
Page 3: Hardware Installation
Installation Guide Hardware installation Install the AMC—optional If an AMC will be added to the CPM, follow the steps in the Promentum™ Advanced Mezzanine Card (AMC) Installation Guide. Install the rear transition module—optional The optional RTM can be hot swapped, so Retaining it can be installed before or after the CPM is installed and while power is applied to... - Page 4 Hardware installation Install the CPM into an ATCA shelf The CPM can be hot swapped, which means it can be installed while power is applied to the shelf. This procedure assumes the power is already applied to the shelf. 1. Determine the node slot where the CPM will be installed. Do not use the slots reserved for the hub modules (ATCA-2210 SCMs).
- Page 5 Installation Guide Figure 1. Serial port connection Serial port RJ-45 cable Computer terminal COM port Connect a CD-ROM drive to the USB port Connect a CD-ROM drive to the USB port on the front panel of the CPM. Figure 2 illustrates this connection.
- Page 6 The CPM reboots and loads the operating system from the CD after BIOS changes are saved and you exit the BIOS. These instructions describe how to install an OS and related RadiSys software. 1. Use the installation directions provided by the OS vendor to install the OS. If you install a version of Red Hat, be sure to perform the installation in serial mode, which is needed for a device using a serial connection to a terminal.
-
Page 7: Where To Get More Product Information
The driver components and a build script are provided in an RPM update bundle on the CD. If a standard RadiSys-provided kernel OS package is used, install the corresponding amifldrv.rpm from the CD. The installation process names the driver amifldrv_mod.o and places it in the following directory: /lib/modules/’uname -r’/extra/amifldrv/...