Connect External I/O Devices And Chassis Components - RadiSys PROCELERANT CE915GM Quick Start Manual

4
Assembling the Module and Carrier Board

Connect external I/O devices and chassis components

Connect external devices to the connectors on the rear I/O panel of the CR100 carrier board.
1. Connect the keyboard and mouse to any of the USB ports.
2. If you have a CR100-2DVI carrier board, connect one or two monitors according to your
3. If you have a CR100-PCIE16 carrier board, connect one or more displays to the PCI Express
4. Connect the following devices to external ports on the rear I/O panel as needed. The
28
needs. Assuming you have left the jumper in the DVI output selection header to enable
VGA output on the secondary DVI-I connector:
• Connect a digital video monitor to the primary DVI-I connector.
• Connect a VGA monitor to the secondary DVI-I connector. If the VGA monitor cable has
a DB15 connector, you will need a DVI-to-VGA adaptor as shown below (RadiSys
product code CE-DVI-VGA).
DVI side of adaptor
graphics card according to the instructions provided with the graphics card.
installation order is not important. For additional information, refer to the Product Manual
and the Procelerant CR100 FlexATX Carrier Board Product Manual.
Device to connect
TV or other S-Video–compatible
device
LAN, router, or other Ethernet
device
Microphone and speaker
The CR100 carrier board does not provide an on-board PC speaker. It is recommended that you
connect an external speaker to the front panel I/O header in order to hear diagnostic sounds during
system boot.
CR100 connector
S-Video output port (located on
front of CR100 carrier board)
Ethernet port
Audio jacks
NOTE
VGA side of adaptor
Cable type
Standard MiniDin4 male S-Video
cable
For 10/100Base-T connections, a
Cat5 cable is required; for
1000Base-T, a Cat5E cable is
required.
Standard audio cables with
3.5mm male connectors