Install The Cr100 Carrier Board In The Chassis; Connect Internal Devices And Set Jumpers - RadiSys PROCELERANT CE915GM Quick Start Manual

4
Assembling the Module and Carrier Board

Install the CR100 carrier board in the chassis

1. Prepare a chassis designed to accept a standard FlexATX-sized board.
2. Remove any I/O shielding included with the chassis, and replace it with the CR100 carrier
3. Fit the module and carrier board assembly into the chassis and snap the carrier board's rear
4. Use the screws and standoffs supplied with the chassis to mount the carrier board. Torque

Connect internal devices and set jumpers

This section gives the procedure for connecting internal devices to the CR100 carrier board,
such as disk drives and LAN cards, and configuring jumper settings.
1. Connect the following internal devices to connectors on the carrier board as needed. The
Device to connect
Up to two internal USB devices
PCI Express x1 device, such as a LAN card
One IDE device, such as a CD-ROM drive or
hard disk drive
Up to two SATA devices, such as hard disk
drives
One LVDS flat panel
One backlight control connector for the
LVDS flat panel
2. If you have a CR100-2DVI carrier board, you may need to specify which DVI-I connector will
26
board's I/O shielding from RadiSys.
I/O panel into the I/O shielding.
To avoid electromagnetic interference, ensure that the springs on the I/O shielding are in full contact
with the CR100 carrier board's rear I/O panel.
values vary according to the size and material of the screws used. Check with your chassis
manufacturer for the recommended torque values of any screws they provide.
installation order is not important.
For further information about attaching devices, refer to the Procelerant CR100 FlexATX
Carrier Board Product Manual.
output VGA signals with the 2-pin DVI output selection header. For instructions on
connecting a DVI digital video monitor or analog VGA monitor, see
devices and chassis components
• Pins 1 and 2 jumpered (default)—Obtains analog VGA output from the secondary DVI-I
port J2
• Pins 1 and 2 open—Obtains VGA output from the primary DVI-I port J1
Note
CR100 connector
Internal USB headers
PCI Express x1 slot
IDE header
SATA connectors
LVDS flat panel connector
Backlight control connector Custom; attaches to 7-pin 1.25mm
on page 28.
Cable type
Standard 5-pin USB cable
N/A
Standard IDE cable, complies with the
ATAPI industrial specification
Standard SATA cable, compliant with
SATA specification 1.0
Standard 30-pin LVDS cable
header
Connect external I/O