Connector Board - HP EliteBook x360 1030 G7 Maintenance And Service Manual

NOTE: The connector board cable is available in the Cable Kit, spare part number M20833-001.
Before removing the connector board cable, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Disconnect the battery cable from the system board
Remove the connector board cable:
1. Release the zero insertion force (ZIF) connector (1) to which the connector board cable is connected, and
then disconnect the cable from the system board.
2. Release the ZIF connector (2) to which the connector board cable is connected, and then disconnect the
cable from the connector board.
3. Remove the connector board cable (3).
Reverse this procedure to install the connector board cable.

Connector board

To remove the connector board, use this procedure and illustration.
Table 5-5 Connector board description and part number
Description
Connector board (includes audio-out (headphone)/audio-in (microphone) combo jack, nano SIM card slot
(select products only), and USB SuperSpeed port)
NOTE: The connector board spare part kit does not include the connector board cable. The connector board
cable is available in the Cable Kit, spare part number M20835-001.
Before removing the connector board, follow these steps:
ENWW
(Preparation for disassembly on page
(Bottom cover on page 42).
42).
(Battery on page 43).
Component replacement procedures
Spare part number
M16050-001
49