Solid-State Drive - HP EliteBook x360 1030 G7 Maintenance And Service Manual

Solid-state drive

To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-3 Solid-state drive descriptions and part numbers
Description
2 TB, M.2 2280, PCIe-NVMe 3×4, SS solid-state drive with TLC
1 TB, M.2 2280, PCIe-NVMe 3×4, SS solid-state drive with TLC
512 GB, M.2 2280, PCIe-3×4, SS solid-state drive with TLC
512 GB, M.2 2280, PCIe, NVMe, SED solid-state drive with TLC
512 GB, M.2 2280, PCIe, NVMe, value solid-state drive
256 GB, M.2 2280, PCIe-3×4, SS solid-state drive with TLC
256 GB, M.2 2280, PCIe, NVMe, SED solid-state drive with TLC
256 GB, M.2 2280, PCIe, NVMe, value solid-state drive
128 GB, M.2 2280, SATA-3 solid-state drive with TLC
512 GB, M.2 2280, PCIe + 32 GB, 3D Xpoint solid-state drive
256 GB, M.2 2280, PCIe + 16 GB, 3D Xpoint solid-state drive
Before removing the solid-state drive, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Disconnect the battery cable from the system board
Remove the solid-state drive:
1. Remove the solid-state drive shield from the system board.
NOTE:
ENWW
(Bottom cover on page
The solid-state drive shield is not available as a spare part.
(Preparation for disassembly on page
42).
(Battery on page
Spare part number
L85358-005
L85348-005
L85360-005
L85368-005
L85364-005
L85350-005
M07245-005
L85354-005
L85346-005
L85366-005
L85356-005
42).
43).
Component replacement procedures 45