9.
Remove the left speaker (4).
NOTE:
absence of or damage to these isolators can result in degraded left speaker performance.
Reverse this procedure to install the speakers.
Touchpad cable
To remove the touchpad cable, use this procedure and illustration.
NOTE:
The touchpad cable is available in the Cable Kit, spare part number M20833-001.
Before removing the touchpad cable, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the bottom cover
3.
Remove the battery
Remove the touchpad cable:
1.
Release the ZIF connector (1) to which the touchpad cable is connected, and then disconnect the cable
from the system board.
2.
Release the ZIF connector (2) to which the touchpad cable is connected, and then disconnect the cable
from the touchpad.
54
Chapter 5 Removal and replacement procedures for authorized service provider parts
When removing the left speaker, make note of the location of the rubber isolators (5). The
(Bottom cover on page
(Battery on page
(Preparation for disassembly on page
42).
43).
42).
ENWW