Table of Contents
Advertisement
4.
If it is necessary to replace the hard drive connector adapter, slide the adapter (1) off of the front end of
the hard drive.
5.
If it is necessary to replace the hard drive bracket, release the sides of the bracket from the hard drive,
and then lift the bracket straight up (2) and remove the bracket from the hard drive.
The hard drive bracket and hard drive connector adapter are included in the Hard Drive Hardware Kit,
spare part number 808238-001
Reverse this procedure to reassemble and install the hard drive.
Connector board
Description
Connector board (includes cable, SD card slot, USB port, and double-sided adhesive)
Before removing the connector board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the keyboard/top cover (see
5.
Disconnect the battery cable from the system board (see
Remove the connector board:
26
Chapter 5 Removal and replacement procedures
Keyboard/top cover on page
Battery on page
Spare part number
809831-001
21).
23).
Advertisement
Table of Contents
