Sensor Board - HP EliteBook x360 1030 G7 Maintenance And Service Manual

1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery
4. Remove the system board (see
Remove the sensor board cable:
1. Turn the system board upside down with the rear toward you.
2. Release the ZIF connector (1) to which the sensor board cable is connected, and then disconnect the cable
from the system board.
3. Release the ZIF connector (2) to which the sensor board cable is connected, and then disconnect the cable
from the sensor board.
4. Remove the sensor board cable (3).
Reverse this procedure to install the sensor board cable.

Sensor board

To remove the sensor board, use this procedure and illustration.
Table 5-12 Sensor board description and part number
Description
Sensor board:
NOTE: The sensor board spare part kit does not include the sensor board cable. The sensor board cable is available in the Cable Kit,
spare part number M20835-001.
For use only on computer models equipped with a microphone
For use only on computer models not equipped with a microphone
64 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Bottom cover on page
(Battery on page 43).
System board on page
42).
58).
42).
Spare part number
M16047-001
M16046-001
ENWW