Touchpad - HP EliteBook x360 1030 G7 Maintenance And Service Manual

3. Remove the touchpad cable (3).
Reverse this procedure to install the touchpad cable.

Touchpad

To remove the touchpad, use this procedure and illustration.
Table 5-7 Touchpad description and part numbers
Description
For use only on computer models equipped with NFC capability
For use only on computer models not equipped with NFC capability
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery
Remove the touchpad:
1. Detach the touchpad cable (1) from the top cover/keyboard. (The touchpad cable is attached to the top
cover/keyboard with double-sided adhesive.)
2. Release the ZIF connector (2) to which the touchpad cable is connected, and then disconnect the cable
from the system board.
Steps 3 and 4 apply only to computer models equipped with an NFC module and cable.
3. Detach the NFC module cable (3) from the top cover/keyboard. (The NFC module cable is attached to the
top cover/keyboard with double-sided adhesive.)
ENWW
(Preparation for disassembly on page
(Bottom cover on page
(Battery on page 43).
42).
Component replacement procedures
Spare part number
M16048-001
M16056-001
42).
55