Wwan Antenna - HP EliteBook x360 1030 G7 Maintenance And Service Manual

Before removing the sensor board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery
4. Remove the system board (see
Remove the sensor board:
1. Turn the system board upside down with the rear toward you.
2. Release the ZIF connector (1) to which the sensor board cable is connected, and then disconnect the cable
from the system board.
3. Detach the sensor board (2) from the system board. (The sensor board is attached to the system board
with double-sided adhesive.)
4. Remove the sensor board (3) and cable.
Reverse this procedure to install the sensor board.

WWAN antenna

To remove the WWAN antenna, use this procedure and illustration.
Table 5-13 WWAN antenna description and part number
Description
WWAN antenna (includes left and right cables and transceivers and adhesive)
Before removing the WWAN antenna, follow these steps:
ENWW
(Preparation for disassembly on page
(Bottom cover on page
(Battery on page 43).
System board on page
42).
58).
Component replacement procedures
42).
Spare part number
M20836-001
65