OSD TURN OFF
OSD LOCK OUT
Sets the Zoom method.
The image is expanded to full screen regardless of the resolution.
The image is expanded without changing the aspect ratio.
Turns the [RESPONSE IMPROVE] function [ON] or [OFF]. This function may reduce blurring that occurs in
some moving images.
Selects the language used by the OSD. After selecting language, press the ENTER button.
Turns off the LED light on the monitor bezel when [POWER INDICATOR] is set to [OFF].
The compliance marks that are shown when powering on the monitor the first time are not shown when
switching inputs. The compliance marks are not shown again unless the AC power cord has been
disconnected and reconnected.
If you select [ON], it prevents the compliance marks from being shown when powering on the monitor.
The OSD menu will stay open as long as it is in use. You can select how long the monitor waits after the
last touch to turn off the OSD menu. The preset choices are 5 - 100 seconds by 5-second increments.
This control completely locks out access to all of the OSD control functions except for [BRIGHTNESS],
[CONTRAST], [VOLUME], and input change.
To activate the [OSD LOCK OUT] function, open the OSD menu, select [OSD LOCK OUT], then hold
down the EOTER button over 5 seconds and press the EXIT button simultaneously. To deactivate, hold
down the EXIT button over 5 seconds and press the EOTER button simultaneously.
Selects how power through the USB Type-A port and USB-C port, input signal from USB-C, and external
communication of USB are enabled in relation to the monitor's power status.
AUTON: Power is supplied to the USB downstream port depending on the monitor's power condition.
OON: Power is always supplied to the USB downstream port and USB-C port even when the monitor is in
power save mode or power OFF.
Power consumption depends on the connected USB device even when a monitor's power is off.
Actual power consumption depends on the connected USB device even when the monitor's
power is off.
To avoid data loss, before changing the setting, ensure that no USB storage devices are in use by
the operating system.
Selecting [FACTORY PRESET] allows you to reset all OSD control settings back to the default settings
Information about the current display resolution and technical data, including the preset timing being used
and the vertical frequencies, and indicates the model and serial numbers of your monitor.