Setup
For box contents, please refer to the printed contents sheet provided in the box.
The accessories included depends on the location where the monitor was shipped.
To attach the base stand to the monitor standN:
1. Place monitor face down on a non-abrasive surface (Figure 1).
2. Please rotate the monitor stand 90 degrees as shown in Figure 1.
CAUTIOON:
Please refer to
3. Attach the base stand to the monitor stand, then tighten the screw at the
base's bottom (Figure 2).
OOTEN:
Reverse this procedure if you need to re-pack the monitor.
AROIONN:
Please refer to
To connect the monitor to your system, follow these instructionsN:
OOTEN:
Make sure to read
"Important Information" on page 3
1. Turn off the power to your computer.
2. Place your hands on each side of the monitor to tilt the panel to a maximum tilt angle and lift up to the highest position
(Figure 3).
"CAUTION
5".
"WARNING
8".
before installation.
Figure 3
English−15
90°
Figure 1
Maximum Tilt
Screw
Figure 2