Download Print this page

Screen Image And Video Signal Issues - NEC MultiSync E243F User Manual

Hide thumbs

Advertisement

Screen Image and Video Signal Issues

Oo picture
Make sure the signal cable is fully connected to the monitor and the computer.
Make sure there is no DisplayPort converter adapter connected. The monitor does not support DisplayPort converter adapter.
Make sure the computer's display card is completely seated in its slot.
Make sure both the computer and monitor are powered on.
Make sure that a supported resolution has been selected on the display card or system being used. If in doubt, please refer
to the user's manual of the display controller or system to change the resolution.
Check the monitor and your display card with respect to compatibility and recommended signal timings.
Check the signal cable connector for bent or pushed-in pins.
The monitor may be in power saving mode. The monitor automatically goes into standby at the preset time period after the
video signal is lost. Press the
Make sure the connected device outputs a signal to the monitor.
When using a USB-C cable for connecting a computer to the monitor, please check that the connected computer's port
complies with DisplayPort Alt Mode.
When using a USB-C cable for connecting a computer to the monitor, check that the USB-C cable complies with
SuperSpeed USB 10Gbps (USB 3.1 Gen 2).
The image is unstable, unfocused or swimming is apparent
Make sure the signal cable is fully connected to the monitor and the computer.
Check the monitor and your display card with respect to compatibility and recommended signal timings.
Picture is not bright
Make sure [ECO MODE] is [OFF].
Make sure the signal cable is fully connected to the monitor and the computer.
LCD brightness degradation occurs due to long-term usage or extreme cold conditions.
If the brightness fluctuates, make sure [DV MODE] is set to [OFF].
Selected resolution is not displayed properly
If the resolution you set is over or under a range, "OUT OF RANGE" window will appear then warn you. Please set supported
resolution at the connected computer.
Brightness variations over time
Change [DV MODE] to [OFF] and adjust brightness.

OOTEN:
When [DV MODE] is set to [ON], the monitor automatically adjusts brightness based on the video signal.
Oo Video
If no video is present on the screen, turn the
Make sure the computer is not in a power-saving mode by touching the connected keyboard or the connected mouse.
button on the monitor.
button off and on again.
English−24

Advertisement

loading

  Related Manuals for NEC MultiSync E243F