Remote Control Box Installation - SELVA MARINE MADEIRA 40 Owner's Manual

Trim-angle adjusting - models with Shock Absorber
Release the Shock Absorber through the control lever. Tilt the motor and
keep it in this position through the tilt-supports. Insert the trim-adjusting pin
in the position of correct trim. Lower the supports and place the motor in
the original position. Fasten the Shock Absorber releasing the control
lever.
Trim- angle adjusting - models with Swivel Bracket
Lift the anti-tilt hook, lift the motor and place the trim- adjusting pin in the
position of correct trim, lower the motor and the anti-tilt hook.
Improperly distributed loads on boat or in different positions
can alter the ideal trim conditions.
You may adjust the trim angle when the engine is switched off.

REMOTE CONTROL BOX INSTALLATION

To install the remote control box and the cables we suggest
you contact an official dealer SELVA MARINE.
We suggest you contact this dealer also for the control device
installation.
Picture No. 34
Position of the remote control box
When positioning the remote control box pay attention that the control
lever can be gripped and operated comfortably and without obstacles.
Even the cables must be put in order not to have any obstacle on their
patch and must not get in the way of the passengers. Be sure that the
cables are long enough and that they can't get entangled when the
steering-wheel is operating
Picture No. 35
https://www.boat-manuals.com/
21
An improper installation of a remote control box may cause a
sudden and unexpected loss of control, of the boat. In case or
doubts about the remote control installation, ask your SELVA
MARINE dealer.
Normally the remote control box is supplied to be in positioned
on the right.
If you need to have it on the opposite side, ask your dealer.
If the cables aren't correctly installed, they can get entangled
causing the loss of control of the boat.
Picture No. 36