Control Cables Connection - SELVA MARINE MADEIRA 40 Owner's Manual

Never bind or entangle the cables of the remote control box.
They mustn't be bound with a bending ray inferior to 300 mm.
(12 feet).
The cables aren't included in the supply of the motor.
They must be of the type C2.

CONTROL CABLES CONNECTION

To make the connection of the control cables you have to use the Kit K44
(included in the supply) made by:
Nr 4 Remote control heads
" 2 Sheath retainer bolts
" 4 Screws TC Phillips M5x20
" 4 Self-locking nuts M5
" 2 Split pins
" 4 Washers Grower M5
" 2 Seeger rings
" 3 Screws TSPTC M6x100
" 3 Washers M6
" 3 Self-locking nuts M6
" 1 Clamp
Side of the remote control box
To connect the control cables to the box you have to follow the following
instructions:
•
Remove the lower cover (6) of the remote control box by
unscrewing the two screws.
•
Put the control lever (1) in neutral position.
•
Screw completely the gear to connect the remote control box (9) to
the threaded extremity of the cables and fix them with the counter-
nut, paying attention not to tighten it too much.
Picture No. 37
•
Put the head of the gear-control lever in the pawl of the gear lever
(10) and insert the retaining ring (8).
•
Insert the head of the gas-control cable in the pawl of the
accelerator lever (11) and insert the retaining ring.
•
Fix the sheathing of the cables inserting the sheathing-retainer in
its housing.
•
Screw the lower cover.
Remote control box fixing
After having connected the remote control cables, place the box in the
determined position and fix it through the accessories (3 screws M6x100 -
3 washers M6 - 3 self-locking nuts M6) included in the Kit K44.
https://www.boat-manuals.com/
22
Picture No. 38
Picture No. 39