Emergency Stopping Procedures; Stopping In Normal Conditions; Stopping For A Long Period Of Storage - SELVA MARINE MADEIRA 40 Owner's Manual

STOPPING PROCEDURE

Emergency stopping procedures.

In an emergency you can stop your motor by pulling the engine
stop switch lanyard.
To start the motor again you have to install again the lanyard's
lock plate on the engine stop switch.

Stopping in normal conditions

Place the control lever (remote control box) in the neutral position " N ".
Accelerate lightly using the gas lever in neutral position. Turn the switch
key till the OFF position.

Stopping for a long period of storage.

If you will not use the motor for several days, you should stop the engine in
the following way:
Run the engine at idling speed, place the gear-shift lever in the neutral
position " N "and keep the choke knob pulled until the engine stops.
RESTART AFTER A LONG STOP PERIOD OR AFTER EMPTING THE
LUBRICATION CIRCUIT
After along stop period or after empting the lubrification circuit, it's
necessary to add 1% adequate oil to the gasoline in the tank operating the
engine at slow speed for the first half hour.
This procedure will allow the oil pump to fill up the oil lines removing any
eventual presence of air in the circuit that may casue serious damage to
the engine.
Picture No. 60.
working.
Before operting the motor with pure gasoline check that the oil delivery
pipes are full.
Picture No. 61
for the motor and compromise its functionality.
https://www.boat-manuals.com/
33
During this period check the efficiency of the pump properly
If you don't care about this procedure, it could be dangerous