Step 8: Carefully Place The Table Back Down On The Floor.; Step 11: To Lower The Side Closest To You (Handle Side) - SMITH SYSTEM UXL Nest and Fold Table Assembly Instructions

Step 8: Carefully place the Table back down on the floor.

Step 9: Check the level of the Top using a level or measure the distance from each corner of the
top to the floor with a tape measure.
Step 10: If necessary, adjust the level of the Top using the two screws on the Leg Plate.
Step 11: To Lower the side closest to You (handle side):
Loosen (turn counter-clockwise) the Screw farthest away from you ½ turn and Tighten (turn
clockwise) the Screw closest to you. Do this for both Legs. (1/2 turn will adjust approximately 0.5
degrees).
To Raise the side closest to You (handle side):
Loosen (turn counter-clockwise) the Screw closest to you ½ turn and Tighten (turn clockwise)
the Screw farthest away from you. Do this for both Legs. (1/2 turn will adjust approximately 0.5
degrees).
Step 12: Recheck the level of the Top using the level or tape measure and repeat Step 11 if needed. If
level at this point skip to Step 14.
For assistance in assembling product, missing or damaged parts, or to place an order, please contact customer
Form #179977
LEG
PLATE
service at 800-328-1061.
You may also place your order online at
www.smithsystem.com
04/2018