Slave Mode; Fixture Settings - SHOWTEC ACT PC 60 RGBW User Manual

ACT PC 60 RGBW
● Show1 – Show9:
In each submenu under Show1 to Show9 you can further adjust the following parameters:
Speed:
Zoom:
Zoom Cont:

Slave Mode

In this pop-up submenu menu you can activate master/slave control mode.
01) Press the UP/DOWN buttons to select one of the following 3 options:
● Master (0):
● Slave1 (1):
● Slave2 (2):
02) Press the ENTER button to confirm the selection.
Note: Make sure that all slave devices in one master/slave setup are set to the same slave line,
otherwise they will not operate as the master device. Select either Slave1 or Slave2 for all
slave devices in the same master/slave setup.

Fixture Settings

In this menu you can adjust the fixture settings.
01) Press the UP/DOWN buttons to toggle between Dimmer Curve and Dimmer Speed.
● Dimmer Curve:
Product code: 34020
Select one of the 9 built-in chases
Set the speed of the built-in chase. The adjustment range is 000–099
Set the zoom. The adjustment range is 000–255
Activate the automatic zoom-in and zoom-out function (No/Yes). If you
select Yes, the device will continuously zoom in and zoom out
The device will operate as a master device in master/slave mode
The device will operate as a slave device in master/slave mode on line 1
The device will operate as a slave device in master/slave mode on line 2
There are 4 options available: Linear, Square Law, Inverse Square Law and
S-Curve
26