Dmx Address / Dmx Channels; Slave Mode; System Settings - SHOWTEC Colorburst V1 Manual

Colorburst
07) If you choose the laser settings, press the Up and Down buttons to choose between
output), (only red output),
08) If you choose the strobe settings from the laser, press the Up and Down buttons to set the strobe.
The adjustment range is between
controlled strobe.
09) If you choose to set the rotation direction, press the Up and Down buttons to select
(automatic rotation between clockwise and counterclockwise),
(counterclockwise).
10) If you choose to set the rotation speed, press the Up and Down buttons to set the speed. The
adjustment range is between

4. DMX Address / DMX Channels

With this menu you can choose a DMX configuration and set the DMX address.
01) Press the Menu button until the display shows
02) Press the Enter button, the display will show
03) Press the Enter button again to open the submenu.
04) Press the Up and Down buttons to choose between
05) Choose the desired configuration and press the Enter button to open the submenu.
06) Press the Up and Down buttons to set the desired DMX address.
07) If you choose the
08) If you choose the
09) If you choose the

5. Slave mode

With this menu you can set the device as a Slave.
01) Press the Menu button until the display shows
02) Press the Enter button to activate the slave mode, the display shows
03) If the device has not been set to slave, it is automatically classified as a master device. All slave
devices will follow the master movement. If the device has been set to slave, it will react the same as
its master device.

6. System Settings

With this menu you can set several system functions.
01) Press the Menu button until the display shows
02) Press the Enter button to open this menu.
03) Press the Up and Down buttons to choose between 4 settings:
LED display on/off
LED display reverse
IR remote control on/off
Reset to default settings
04) If you have chosen
05) Press the Up and Down buttons to choose between
06) If you choose
07) If you choose
08) If you have chosen
Ordercode: 43163
(only green output) or
configuration, the adjustment range is between
configuration, the adjustment range is between
configuration, the adjustment range is between
, press the Enter button to set the LED display ON or OFF.
, the display will continuously light up.
, the display will turn off after 40 seconds, the display will show
, press the Enter button to set the display in reverse mode.
, from slow to fast and
, from slow to fast.
.
.
, or
.
.
18
(no laser
(red and green output).
is the sound-
(clockwise) or
.
.
.
.
.
.
.