Table of Contents
Advertisement
One Chaotic LED
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
When the Chaotic LED is not connected by a DMX-cable, it functions as a stand-alone device.
The Chaotic LED will automatically change its color to the beat of the music. With the Audio
sensitivity control you can adjust its music-sensitivity.
Sound-activated
Sound-activated with strobe (1-20 Hz)
Sound-activated with Auto Color changing
Multiple Chaotic LEDs
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Use a 3-p XLR cable to connect the Chaotic LED.
The pins:
3. Link the units as shown in (Fig. 3), Connect a DMX signal cable from the first unit's DMX "out"
socket to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
4. There are 4 options to setup a master-slave chain:
You can use the same functions on the master device as described on page 7+8 (Built-in
Programs 1-3, and
operation Mode and all slave devices will react the same as the master device.
(Sound
control)
(Master/Slave control)
1.
Earth
2.
Signal -
3.
Signal +
Sound-active Master Control:
Auto 1 Master Control:
Auto 2 Master Control:
Auto 3 Master Control:
Music control). This means on the master device you can use your desired
Music Control 1
Music Control 2
Music Control 3
Slave Control:
Dipswitch #11+12 should be set to ON
Slave Control:
Dipswitch #1 should be set to ON
Dipswitch #10+12 should be set to ON
Slave Control:
Dipswitch #1 should be set to ON
Dipswitch #12 should be set to ON
Slave Control:
Dipswitch #1 should be set to ON
8
: All Dipswitches set to OFF
: Dipswitch #10 and #11 set to ON
: Dipswitch #11 set to ON
Dipswitch #10 should be set to ON
Dipswitch #1 should be set to ON
Advertisement
Table of Contents
