Standard Equipment And Spare Parts - SaMASZ KDT 180 Operator's Manual
Rear disc mower
Hide thumbs
Also See for KDT 180:
- Operator's manual (52 pages) ,
- Operator's manual (24 pages) ,
- Operator's manual (52 pages)
Table of Contents
Advertisement
3-point linkage frame (1) enables attachment of the mower to tractor's 3-point linkage. Drive
from tractor's rpm is transmitted through
cutterbar, there are discs with two knives each. Apart from that, drive from tractor's rpm through
(9) and PTO shaft (10) is transmitted to tine conditioner (8). Hydraulic cylinder (2) is
chain gear
used to adjust the mower to working position. It is supplied from outer hydraulics of the tractor.
Main frame, on which the cutterbar (4) is situated, is supported by the springs (7). Swath guides (5)
are mounted on the main frame.
1
Fig. 3c. Parts of SaMASZ rear disc mower with tine conditioner
1 – 3-point linakge frame
2 – Hydraulic cylinder with support springs
3 – Intersecting axis gear
4 – Cutterbar
5 – Swath guides
3-point linkage frame (1) enables attachment of the mower to tractor's 3-point linkage. Drive
from tractor's rpm is transmitted through
cutterbar, there are disco with two knives each. Apart from that, drive from tractor's rpm through
(3) and PTO shaft (10) is transmitted to roller conditioner (8). Hydraulic
Intersecting axis gear
cylinder (2) is used to adjust the mower to working position. It is supplied from outer hydraulics of
the tractor. Main frame, on which the cutterbar is situated, is supported by the springs (7). Swath
guides (5) are mounted on the main frame.
3.3. Standard equipment and spare parts
The mowers are sold with the following standard equipment:
warranty card,
operator's manual with spare parts list,
cutting knives: additional set,
PTO shaft with overrunning clutch,
spray paint (150 ml).
Optional extra equipment:
warning plate with combined lights and reflectors,
warning triangle.
Operator's manual
intersecting axis gear
2
7
10
3
intersecting axis gear
Rear disc mowers
KDT 180; KDT 220 S/W; KDT 260 S,SL/W;
KDT 300; KDT 340
(3) on the cutterbar (4). On the
5
6 – Safety guard
7 – Springs
8 – Roller conditioner
9 – Chain gear
10 – PTO shaft
11 – Support legs
(3) on the cutterbar (4). On the
-
-
6
8
11
4
6
Advertisement
Table of Contents
