Preparing The Mower For Transport - SaMASZ KDT 180 Operator's Manual

S
W
Fig. 8. Connecting the mower to
the tractor
CAUTION:
Before disconnecting the mower put the pin 1 (Fig. 9a) into the hole 3 in the
bar (Fig. 9a) to secure the linkage against falling. When the mower is
connected the pin should be in the bush 2 (Fig. 9a) on the middle bar.

5.2. Preparing the mower for transport

To prepare the mower for transport and to meet safety precautions, please do the following:
lift the mower with tractor hydraulic lift until the lower lift pins of the mower 3-point linkage
frame raise about 0,5 m above the ground (Fig. 11),
lift support leg up and secure it with split cotter,
remove the pin 1 and put it into the bush 2 (Fig. 9a),
lift the cutterbar by hydraulic cylinder vertically until the pawl Z locks in (Fig. 9b),
secure the cutterbar against falling by the shut-off valve (Fig. 10b) placed on the mower's
hydraulic cylinder.
CAUTION:
During transport the shut-off valve of mower hydraulic lift should always be
closed – the valve lever in Z position (Fig. 10). It protects the mower against
incidental falling in case of hydraulic failure.
O
a)
Fig. 10. Shut-off valve position: a) open(work), b) closed(transport)
Operator's manual
Ł
A
-
Rear disc mowers
KDT 180; KDT 220 S/W; KDT 260 S,SL/W;
KDT 300; KDT 340
a)
b)
Fig. 9. a) 1 - pin, 2 - bush,
3 – hole in the bar b) Z - lock
b)
-
18
1
2
3
Z
Z