Data Plate; Steam / Reheating Operation - Blodgett Combi Manual Control BCM Service & Installation Manual

Table of Contents

Advertisement

Data Plate

When communicating with BLODGETT, we kindly ask
you inform us of the serial number of the oven that is
stated on the approval plate. The approval plate is
located on the right-hand corner post of the oven
cabinet, as shown below.
The BLODGETT Technical Support, whose experience
and expert knowledge are at your disposal, can be
contacted at tel. # 800-331-5842 and fax # 802-652-2814.
Drain connection
From the factory, the BLODGETT ovens are equipped with
a drain system that removes surplus water from the oven
chamber. This water may be condensed water from the
products, or it may occur when the oven chamber is cooled
down with cold water, or when the oven chamber is cleaned.
Connection must be carried out by an
authorised plumber, to an open or to a
closed drain.
It is recommended that a water outlet
is available/established in the floor of
the room where the oven is located.
The drain must never end directly beneath
the oven.
The drain must be of copper or an equally temperature
-resistant material, have a diameter of at least 2" (50mm)
and a fall of at least 3° or 5%.
Installation and Connections

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Manual Control BCM and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents