Blodgett Combi Manual Control BCM Service & Installation Manual page 10

U10 Programs
You activate the program mode by pressing the step key.
0= OFF, 1= 10 programs with 3 process steps.
NOTE: It is still possible to activate the cleaning program even though the program mode
is not active.
0= OFF.
U11 Core temperature probe
You activate and deactivate the core temperature probe by pressing the step key.
0= OFF, 1= ON.
U12 Drain cooling
You activate and deactivate drain cooling by pressing the step key.
0= OFF, 1= ON.
U13 Timer start
You activate or deactivate timer start by pressing the step key.
0= OFF, 1= ON.
U14 Demo
You activate or deactivate the demo mode by pressing the step key.
0= OFF, 1= ON.
NOTE: If the demo mode is on (1= ON), the oven will run without heating elements and
steam generator being switched on.
When the oven starts, it will let you know whether the demo mode is on.
U15 Initialising
You reset the controller by pressing the alarm key.
- 10 -