Wallbeds Australia AB-4a Assembly Instructions Manual page 5

Step 2 Ab-4a Drawer Unit Assembly

Start the cabinet assembly by using either one of the End Panels.

Back Panel - Ensuring the cam locks are facing away from the inside. Place the cabinet back

panel onto the side panel. Match up the cam locks with the cam pins. Tighten the cam locks

and cam pins together by using a Phillips head hand screwdriver.

Bottom Panel - With the cam locks facing away from the inside of the cabinet attach the

bottom panel to the end panel and back panel. Refer to images 6&7 page 11

Top Panel - With the cam locks facing the inside of the cabinet attach the bottom panel to

the end panel and back panel. - Ensure the cam locks are facing the inside of the cabinet.

Kick / Rail Panel - With the cam locks facing to the back of the cabinet attach the kick panel

to the end panel.

Place the remaining end panel on top of the previously assembled panels. Ensuring the cam

pins are lined up with the cam locks. Tighten the cam pins to the cam locks.

Metal Side Drawer Assembly

Note – There are no guide holes on the underside of the drawer bottom panel for the metal

drawer sides. The dome head screws supplied do not require these holes to be pre-drilled.

Drawer Back Panel to Drawer Bottom Panel - With the cam locks facing the back attach the

drawer bottom panel to the drawer back panel. Tighten cam locks to cam pins. Refer to

image 4 page 10

Metal Drawer sides - Attach the metal drawer sides to the drawer bottom and drawer back

panels using the dome head screws. Refer to images 3&4 page 10. Place assembled drawer

into the drawer unit.

DO NOT ATTACH DRAWER FRONTS UNLESS THE DRAWERS ARE IN THE CABINET.

Attaching Drawer Fronts – To ensure the drawer front is the correct way up. Place drawer

front on to the drawer clips -DO NOT PUSH DRAWER FRONT FULLY ONTO THE DRAWER

CLIPS. Refer to images 8&9 page 12

Starting with the top drawer, gently close the drawer ensuring the top edge of the drawer

is level with the top panel or drawer front above. If the drawer front is higher than the

panel, remove it from the drawer clips and turn the drawer front up the opposite way.

Double-check the drawer front is now level with the cabinet top panel.

Once the drawer front is the correct way up, push the drawer front into the metal sides of

the drawer until you hear the drawer click into place on both sides. Tighten the screws on

the outside of the drawer clips using a Phillips head hand screwdriver. Refer to images

14&15 page 12