Troubleshooting Guide - Abbott FreeGo Training Manual

TROUBLESHOOTING GUIDE

SCREEN DISPLAY
ATTN
PUMP ON HOLD
BATT
BATT EMPTY
BATT
LOW BATTERY
CHRG
PLEASE WAIT
DIAL
NOT SET
DOOR
OPEN
DOSE
DONE
ER##
SYSTEM FAIL
If you have any problems setting up your FreeGo® pump and feed system,
please call Abbott Nutrition on Freephone 1800 22 11 66
POSSIBLE CAUSE
This means that hold time has
elapsed
This means the pump battery
is depleted and the pump has
stopped working
This means the pump
battery is nearly empty and
approximately 20 minutes of
battery operation remain
The battery charge is below
the minimum level to operate
and the pump cannot be used
until minimum charge level
is reached
Pump dial is between two dial
positions e.g. between RUN
and HOLD
This means the door is open
while feeding or priming the
giving set
This shows the pump has
completed delivering the
programmed dose
This indicates a
pump malfunction
ACTION TO TAKE
Turn dial to RUN to restart
the pump
Plug the power cord into a mains outlet and
make sure the power is turned on. The display
will indicate CHRG PLEASE WAIT until pump
is ready to use
Plug the power cord into a mains outlet and make
sure the power is turned on
No action to be taken. Pump is available for
use when the display indicates PUMP READY
TO USE
Turn the dial to the desired position directly
aligning the two dots (on the dial and pump
casing). Continue setting up and operating pump
as normal
Turn dial to HOLD and close the set door. Turn
dial to RUN to restart pump or attempt to prime
the giving set again
If you have finished feeding:
turn dial to OFF/CHRG as the dose has been
delivered (VOL FED has reached your set dose).
Or, if there is more feed to deliver: turn dial to
CLEAR VOL (after 5 seconds, volume will be
cleared). Then turn dial to SET DOSE, and use
the Up and Down arrows to set the remaining
dose to be delivered. Turn dial to RUN to restart
the pump
You should remove the pump from the patient.
Turn the dial to OFF/CHRG and contact Abbott
18