2. Make the settings.
See the chapter
3. Press the Confirm changes button to save the changes.
4. Press Install to device button to write the changes to the device.
6.2.1 Available measurement settings
Parameter name
External input 1 type
selection
External input 2 type
selection
External input 3 type
selection
External input 4 type
selection
CO2 ABC logic state
PIR detection delay
Transmitter update
interval
COV selection
6.3 Configuring change of value (COV) settings
1. Press the Transmit Settings button in the Configurations view.
2. Make the settings.
See the chapter
3. Press the Confirm changes button to save the changes.
4. Press Install to device button to write the changes to the device.
6.3.1 Available change of value (COV) settings
Parameter name
COV limit,
temperature
COV limit, relative
humidity
Produal Oy | Keltakalliontie 18, FI 48770 Kotka, Finland | tel. +358 10 219 9100 | fax. +358 5 230 9210 | info@produal.com
Published: 18.07.2019
Available measurement settings
Values
Default
Off / 0-10V /
Off
0-20mA / Ohms
x0.1 / Ohms x10 /
NTC10K / PT1000
Off / 0-10V /
Off
0-20mA / Ohms
x0.1 / Ohms x10 /
NTC10K / PT1000
Off / 0-10V /
Off
0-20mA / Ohms
x0.1 / Ohms x10 /
NTC10K / PT1000
Off / 0-10V /
Off
0-20mA / Ohms
x0.1 / Ohms x10 /
NTC10K / PT1000
Disabled / Enabled
Enabled
0...5 s
0 s
0 = Off /
Off
30...65535 s
Temperature,
Not selected
Relative humidity /
Measurement
1..4 / External
measurement
1...4 / I2C
measurement 1..3
Available change of value (COV) settings
Values
Default
0,1...50,0 °C
0,5 ºC
0,01...50,00 %rH
5,00 %rH
Information is subject to change without prior notice.
on page 56 for more details.
Description
Input 1 type. The parameter is available only if the
device is equipped with inputs.
Input 2 type. The parameter is available only if the
device is equipped with inputs.
Input 3 type. The parameter is available only if the
device is equipped with inputs.
Input 4 type. The parameter is available only if the
device is equipped with inputs.
Automatic self-calibration of CO
The parameter is available only if the device is
equipped with CO
measurement.
2
PIR detection delay. The parameter is available
only if the device is equipped with PIR.
Transmitter specific update interval. The
transmitter sends the last measured value to base
unit at the specified interval.
COV value selection.
on page 56 for more details.
Description
COV limit for temperature.
COV limit for humidity.
56 (63)
measurement.
2
EN - 5401comm