3. Press the Reset to factory settings button.
4. Press the Reset to factory settings button again to confirm the resetting.
Important: All the device settings are reset to factory defaults. Also the network
settings are reset.
5. Press the OK button on the confirmation dialog.
The settings are now reset factory defaults.
5.2 Reopening existing wireless project
Important: When enabling the Bluetooth in the base unit, the network communication
stops. It can take up to several hours for a big network to resume fully functional condition.
1. Start Produal MyTool
2. Press the Devices button.
The device list shows the devices that has Bluetooth activated.
Note: The Bluetooth is enabled when the supply voltage is connected for the first time.
3. If the device is not showing in the list, press the connection button until the Wireless indicator light
flashes to enable the Bluetooth in the device.
A
A. Connection button
The indicator light should flash after pressing the button for one second.
Note: Use a small screwdriver or a similar tool to push the button.
4. Select the device from the list.
5. Press the Connect button.
CPU indicator light is illuminated continuously when Produal MyTool
Produal Oy | Keltakalliontie 18, FI 48770 Kotka, Finland | tel. +358 10 219 9100 | fax. +358 5 230 9210 | info@produal.com
Published: 18.07.2019
®
.
Information is subject to change without prior notice.
®
is connected to the device.
51 (63)
EN - 5401comm