Removing Devices From Wireless Network - Produal Proxima WBU Commissioning And Maintenance Instructions

6. Press the Commission device button.
7. Press the Re-open wireless project button.
Existing network settings are displayed.
8. Edit the device name if needed.
The device name is also used for the network name.
Note: Don't use any special characters (ä, ö, å, :, [, etc.) in the device name.
9. Press the Next button.
10. Set the transmitter naming pattern.
Use ### to insert transmitter ID to the pattern.
11. Press the Next button.
12. Review the network configuration and press the REBUILD NETWORK button.
13. Select the method to continue.
• Press OK button to return to main view.
• Press Add transmitters to project button to add wireless transmitters to network.
Important: Configure all needed transmitter settings before connecting to the wireless
network.
The base unit deactivates the Bluetooth communication and moves to MIRA communication mode.
The wireless network is now visible in the Wireless installation projects view.

5.2.1 Removing devices from wireless network

1. Reset the network settings in the devices that are going to remove.
See the chapter
2. Connect Produal MyTool
3. Press the Commission device button.
4. Press the Remove Transmitters button.
5. Select the devices to be removed from the network.
6. Press the REMOVE TRANSMITTERS button.
7. Press the OK button.
8. Press the REMOVE TRANSMITTERS button.
The selected devices are now removed from the network.
Produal Oy | Keltakalliontie 18, FI 48770 Kotka, Finland | tel. +358 10 219 9100 | fax. +358 5 230 9210 | info@produal.com
Published: 18.07.2019
Resetting network settings
®
to WBU.
Information is subject to change without prior notice.
on page 50 for more information.
52 (63)
EN - 5401comm