Configuring The Base Unit Settings - Produal Proxima WBU Commissioning And Maintenance Instructions

4 Configuring the base unit settings

To configure the device, you first need to connect it to Produal MyTool
connected to application, you can make changes to the configuration.
1. Connect the supply voltage to the base unit.
2. Start Produal MyTool
3. Press the Devices button.
The device list shows the devices that has Bluetooth activated.
Note: The Bluetooth is enabled when the supply voltage is connected for the first time.
4. If the device is not showing in the list, press the connection button until the Wireless indicator light
flashes to enable the Bluetooth in the device.
A
A. Connection button
The indicator light should flash after pressing the button for one second.
Note: Use a small screwdriver or a similar tool to push the button.
5. Select the device from the list.
6. Press the Connect button.
CPU indicator light is illuminated continuously when Produal MyTool
Produal Oy | Keltakalliontie 18, FI 48770 Kotka, Finland | tel. +358 10 219 9100 | fax. +358 5 230 9210 | info@produal.com
Published: 18.07.2019
®
.
Information is subject to change without prior notice.
®
application. When the device is
®
is connected to the device.
20 (63)
EN - 5401comm