Network Configuring And Commissioning Procedure - Produal Proxima WBU Commissioning And Maintenance Instructions

IN1
Input 1 (0...10 V or NTC 10 or digital).
G0
IN2
Input 2 (0...10 V or NTC 10 or digital).
G0
IN3
Input 3 (0...10 V or NTC 10 or digital). The input supports energy harvesting from 0...10 V signal when
the device is battery powered. The harvesting is active if the signal is over 4 V.
G0
Note: When using 0...10 V inputs, the input potential must be the same that is used in the
connected 0...10 V device. Use common G0 with the connected device's power supply, for
example.
Note: Use NO type contact for digital input, if the device is only battery powered. NC
requires power and that significantly shortens the battery life.
VCC
SCL
I2C
models
SDA
GND
G0 0 V
G 10...30 Vdc / 12...28 Vac

3.5 Network configuring and commissioning procedure

It's recommended to follow the following procedure to be able to configure and commission the
wireless network successfully.
1. Design the network and place the devices.
See the section
2. Configure the base unit settings.
See the section
3. Set up the network.
See the section
4. Configure transmitter settings.
See the section
Produal Oy | Keltakalliontie 18, FI 48770 Kotka, Finland | tel. +358 10 219 9100 | fax. +358 5 230 9210 | info@produal.com
Published: 18.07.2019
3...5 Vdc
Serial clock line.
Serial data line.
0 V
Building the wireless network
Configuring the base unit settings
Setting up a new wireless network
Configuring the wireless transmitters
Information is subject to change without prior notice.
on page 12.
on page 20.
on page 46.
on page 53.
18 (63)
EN - 5401comm