Configuring The Wireless Transmitters - Produal Proxima WBU Commissioning And Maintenance Instructions

6 Configuring the wireless transmitters

To configure the device, you first need to connect it to Produal MyTool
connected to application, you can make changes to the configuration.
Important: Configure all needed transmitter settings before connecting to the wireless
network.
1. Connect the supply voltage to the transmitter.
2. Start Produal MyTool
3. Press the Devices button.
The device list shows the devices that has Bluetooth activated.
Note: The Bluetooth is enabled when the supply voltage is connected for the first time.
4. If the device is not showing in the list, press the connection button until the indicator light flashes
to enable the Bluetooth in the device.
Important: Do not press the connection button within 10 seconds after connecting
supply voltage. It takes up to 10 seconds until the transmitter is fully started and
functional.
A
B
A. Connection button
B. Indicator light
The indicator light should flash after pressing the button for one second.
Note: Use a small screwdriver or a similar tool to push the button.
5. Select the device from the list.
Produal Oy | Keltakalliontie 18, FI 48770 Kotka, Finland | tel. +358 10 219 9100 | fax. +358 5 230 9210 | info@produal.com
Published: 18.07.2019
®
.
Information is subject to change without prior notice.
®
application. When the device is
53 (63)
EN - 5401comm