Reading Beacon Data - Produal Proxima WBU Commissioning And Maintenance Instructions

• Transmitter is restarted.
• The beacon messages are activated by pressing the button.

1.1 Reading beacon data

The wireless devices also support Bluetooth beacon messages. The beacon messages are one-way
messages that can be sent with same time with MIRA and Bluetooth communication. You can't install
transmitters to network using beacon data.
1. Start Produal MyTool
2. Press the Wireless installation projects button.
3. Press the Scan existing installations button.
4. Select the device from the list.
If the wireless device there are ??? on the signal strength, the device is out of the coverage area
or the beacon data has turned off (transmitters send the beacon data for one hour). To remove the
transmitters that are not in the area, press the Clear device list button.
5. If the device is not showing in the list, press the connection button very shortly (under one
second).
The indicator light flashes quickly to indicate the button press.
A
B
A. Connection button
B. Indicator light
Note: Use a small screwdriver or a similar tool to push the button.
Note: If you press the button for over one second, the device Bluetooth activates and
the device is disconnected from the wireless network. Press the button again over one
second to deactivate the Bluetooth.
The transmitter sends the beacon messages for one hour. The beacon messages are also sent for
one hour after the transmitter is connected to a network or restarted.
Produal Oy | Keltakalliontie 18, FI 48770 Kotka, Finland | tel. +358 10 219 9100 | fax. +358 5 230 9210 | info@produal.com
Published: 18.07.2019
®
.
Information is subject to change without prior notice.
5 (63)
EN - 5401comm