Replace Power Cord - Fellowes 220-2 Technical & Service Manual

DO THIS FIRST
Remove Cutting Assembly and
Motor
TOOLS
Long nose pliers
Phillips screwdriver
power cord
wires to
PC board
26

Replace Power Cord

The power cord fits through through the opening on the
back of the cabinet.
To replace the power cord:
1
Make sure the power cord wires are disconnected
from the PC board.
2
Make sure the ground wire is disconnected from
the ground wire tab on the cabinet shelf.
3
Remove the screws that hold the wire guides to
the cabinet shelf and remove the wire guide.
4
Push the the power cord and strain relief through
the opening at the back of the cabinet.
5
Place the new power cord in the cabinet opening.
6
Place the wires inside the wire guide and reattach
the wire guide to the cabinet shelf.
7
Reconnect the wires.
6
Reattach the power cord wires to the PC board
after replacing the motor and cutting cylinder
assembly.
Power Cord
power cord ground wire
strain relief