Remove Motor - Fellowes 220-2 Technical & Service Manual

DO THIS FIRST
Remove Cutting Assembly
Gears
TOOLS
Philips screwdriver
18

Remove Motor

The motor is supplied as a complete assembly. If any
part of the motor is defective, the entire motor must be
replaced.
To remove the motor:
1
Make sure the motor wires are disconnected from
the PC board.
2
Make sure the ground wire is disconnected from
the cabinet shelf.
3
Remove the small drive gear from the motor shaft.
4
Remove the 3 bolts and washers that hold the
motor to the left bearing plate.
5
Support the bearing plate and cutting assembly as
you remove the motor.
motor drive shaft
Motor
Note:
motor
wires
motor
mounting
bracket
Go to the cutting assembly procedures for the
model you are servicing.
ground
wire