Remove Cutting Assembly Gears - Fellowes 220-2 Technical & Service Manual

Remove Cutting Assembly Gears

The cutting assembly gears are the same for the 220-2,
220C-2, C-220, and C-220C shredders. The small white
gear fits over the gray drive gear. The large white gear
fits over the large cutting cylinder gear. Both cutting
cylinder gears are permanently attached to the cutting
cylinders.
To remove the cutting assembly gears:
1
Remove the 6 screws and washers that hold the
gearbox cover to the left bearing plate.
2
Pull the gear box cover away and up from the
bearing plate. The small white gear and the gray
drive gear will remain on the gear box shaft.
3
Remove the large white gear and washer from the
cutting cylinder shaft.
gearbox
large white
gear
small & large cutting
shaft gears (not
shown)
shaft
cutting assembly
DO THIS FIRST
Remove Cutting Assembly and
Motor from Cabinet
TOOLS
Philips screwdriver
Gear puller
small drive gear
small white gear
left bearing plate
motor
right
bearing
plate
17