4.0
Configuration Menu
This section provides an overview of iDimension Plus configuration menu instructions.
4.1
Access Configuration Menu
To access the Configuration Menu, see the following procedure:
1. Select the Device Information function key
2. The Device Info menu displays. For Device Info information
3. Select the Configuration function key
4. The Configuration Menu displays. For additional Configuration Menu information
Item
Setup Wizard
View EULA
Time Zone
Date & Time
Data Extract
Scan Zone
Restart
Enable Flats
Upgrade Firmware
IP Address
Figure 4-1. Device Information
from the Device Info menu.
Figure 4-2. Configuration Menu
Description
Steps through initial configuration to allow unit operation
Displays the Software End User License Agreement information
Displays the current time zone and allows for time zone configuration
Allows the adjustment of date and time
View the configuration settings and the current and previous status;
Must be configuration in administration mode
Allows for configuration of the Zone of Interest
Select to restart the iDimension Plus unit
Select to configure flat detection settings
Allows for a connected USB drive to update the current device firmware
Select to view the current IP address of the iDimension Plus unit
Table 4-1. Configuration Menu Keys
© Rice Lake Weighing Systems ● All Rights Reserved
located at the bottom of the screen
(Section 4.2 on page
Configuration Menu
(Figure 3-1 on page
10).
20).
(Section 4.2.1 on page
20).
Reference
Section 4.1.1 on page 16
Section 4.1.2 on page 16
Section 4.1.3 on page 17
Section 2.1.2 on page 5
Section 4.1.3 on page 17
Section 2.1.3 on page 6
Section 4.1.4 on page 18
Section 4.1.5 on page 18
Section 4.1.6 on page 19
Section 4.1.7 on page 20
15