6
Adjustments
24
Measuring point (MP S) for Supporting Air.
1
2
3
Figure 27 Measuring point for supporting air
!
Attention!
After measuring the air pressure ensure secure connections and a stable state of the applicator and printer.
With a Manometer that is capable of measuring pressures
ranging from -7 to 7 bar the effective pressures can be
measured.
MP S: Support air (desired default value 2 bar)
1. Remove the cover and interpose the manometer at the
MP S .
- Tube (3) from the vent block to the blowpipe connection.
- Connection (2) to the blowpipe.
2. Measure the air pressure by pressing the micro switch (1)
to raise the magnetic valve while the air pressure feed is
open.
3. If required set the air pressure as needed via the throttle
valve.
4. Remount cover.
MP S
24