Hach TitraLab KF1000 Series User Manual page 62

Change application parameters
Parameter
Type
Part of name
Recommended electrode
Working mode
Current (sample analysis) Set the value of the imposed current during sample analysis
Current (titrant calibration) Set the value of the imposed current during titrant calibration
Parameter Description
Name Name of the titrant
Titrant concentration Nominal concentration of the titrant
Resolution Number of decimals of the nominal concentration of the titrant
Real concentration Real concentration of the titrant used for result calculation
Resolution Number of decimals of the real concentration of the titrant
Active Select No to skip this method during titrant calibration
Calibration frequency Recommended frequency of titrant calibration (0 = no reminder)
Stirring speed Speed of the stirrer during titrant calibration
Delay Stirring time before the titration starts
Injection autodetect Automatic start after the detection of the sample injection
End point Ordinate of the end point
Proportional band Proportional band of the PID regulation
Drift threshold Drift value below which the cell is considered as dry
Max. addition speed Maximum speed for titrant addition on titration regulation
Min. titr. duration Set the minimum titration duration
Max. titr. duration Set the maximum titration duration
Resolution Maximum number of decimals to show for the real concentration of the
titrant
Titrant cal. limit check Activate the titrant calibration result boundary check
Min. titrant conc. Minimum value of the real concentration of the titrant
Max. titrant conc. Maximum value of the real concentration of the titrant
Standard name Name of the standard
Standard amount Amount of standard to be used for titer determination
Resolution Maximum number of decimals for the amount value of the standard
Min. amount Minimum amount of the standard
60
Table 21 Electrode
Description
Type of measurement electrode
Part of the name used to identify matching electrodes if the
preferred electrode is not connected
Recommended electrode to be used for this analysis
Specify if the probe is used in imposed voltage/current (AC or DC)
Table 22 Titrant
Titrant calibration
Incremental addition
Titration calculation
Basic mode Expert mode
x
x
x
x
Basic mode Expert mode
x
x
x
x x
x
x x
x x
x x
x x
x x
x
x
x x
x
x x
x x
x
x
x
x
x x
x x
x x
x x