Operation; Zeroing The Display; Taring - Adam ACBplus Series Manual

4.0 OPERATION

4.1

ZEROING THE DISPLAY

 Press the [Zero] key when the platform is empty.
 [Zero] key may be pressed at any time to set the zero point
from which all other weighing and counting is measured.
 When the zero point is obtained the "O" indicator will be on in
the left bottom corner of the LCD.
 The scale has an automatic re-zeroing function to account for
minor drifting or accumulation of material on the platform.
However you may need to press the [Zero] key to re-zero
the scale if small amounts of weight are shown when the
platform is empty.
4.2

TARING

 Zero the scale by pressing the [Zero] key, if necessary.
 The "O" indicator will be on.
 Place a container on the platform, a value for its weight will
be displayed.
 Press the [Tare] key to tare the scale. The weight that was
displayed is stored as the tare value. It is subtracted from the
displayed value, leaving zero on the display. The NET
symbol will be on at the right top corner to indicate that the
weight displayed is the net weight.
 As the product is added, only the net weight will be shown.
 The scale could be tared a second time if another type of
product was to be added to the first one. Again only the
weight that is added after taring will be displayed.
 When the container is removed a negative value will be
shown. If the scale was tared just before removing the
container, this value is the gross weight of the container plus
all products those were removed.
 The "O" indicator will also be on because the platform is back
to the same condition as it was when the [Zero] key was last
pressed.
 To cancel the tare value, press [Tare] again.
© Adam Equipment Company 2004
7