5.0
DISPLAYS
The LCD display will show a value and a unit to the right of the digits.
In addition the LED's above the display will show when a weight is below or above check-
weighing limits.
Other symbols will show when a weight has been tared (NET) the scale is at zero and
stable, if a value has been stored in memory or when the animal weighing function has
been enabled. A battery symbols will show the state of charge of the internal battery.
6.0
OPERATION
6.1
ZEROING THE DISPLAY
You can press the [0/Esc] key at any time to set the zero point. This will
usually be necessary when the platform is empty. You can only zero off a
weight up to a maximum of 20% of the scale capacity. When the zero point is
obtained the display will show an indicator for zero.
The scale has an automatic re-zeroing function to account for minor drifting
or accumulation of material on the platform. However you may need to press
the [0/Esc] key to re-zero the indicator if small amounts of weight are
shown when the platform is empty.
6.2
TARING