272
4-5. Using the driving support systems
■
Displaying the Stop & Start system status
Operation status of the Stop & Start system can be displayed on the
(Drive information) screen of multi-information display. (P. 132)
Smart Stop
After Start
After Reset
The display of "After Reset" can be reset.
●
To reset the display, press
to select "Reset", and then press and hold
●
To stop the reset procedure, press
■
Multi-information display messages
If the following situations,
multi-information display.
●
When the engine cannot be stopped by the Stop & Start system
INNOVA_OM_OM71301E_(GE)
Displays the current engine stop time. Also, the
engine stop time when the air conditioning
system is on can be adjusted using the meter
control switches. (P. 271)
Displays the cumulative time that the engine is
stopped by the Stop & Start system from when
the engine is started until the engine is stopped.
Displays the cumulative time that the engine is
stopped by the Stop & Start system from the
previous reset until the system is reset again.
of the meter control switches, press "" or ""
Message
The brake pedal is not depressed enough.
"Depress
brake
If the brake pedal is depressed further,
firmly to activate"
• The air conditioning system is being used
"For climate con-
If the difference between the set tem-
trol"
• The windshield defogger is turned on.
.
.
and a message may be displayed on the
Details/Actions
the system will operate.
when the ambient temperature is high or
low.
perature and cabin temperature is
small, the system will be enabled.