Battery-Saving Function; Electronic Key Battery-Saving Function; Alarms And Warning Indicators - Toyota INNOVA Owner's Manual

160
3-2. Opening, closing and locking the doors
■

Battery-saving function

The battery-saving function will be activated in order to prevent the electronic
key battery and the battery from being discharged while the vehicle is not in
operation for a long time.
■

Electronic Key Battery-Saving Function

When battery-saving mode is set, battery depletion is minimized by stopping
the electronic key from receiving radio waves.
Press
holding
key indicator flashes 4 times.
While the battery-saving mode is set, the
smart entry & start system cannot be
used. To cancel the function, press any of
the electronic key buttons.
■

Alarms and warning indicators

A combination of exterior and interior alarms as well as warning messages
shown on the multi-information display are used to prevent theft of the vehicle
and accidents resulting from erroneous operation. Take appropriate mea-
sures in response to any warning message on the multi-information display.
The following table describes circumstances and correction procedures when
only alarms are sounded.
Alarm
Exterior
sounds once for 5
seconds
Interior
pings
ously
INNOVA_OM_OM71301E_(GE)
twice while pressing and
. Confirm that the electronic
Situation
alarm An attempt was made to lock
the vehicle while a door was
open.
The engine
turned to
alarm mode while the driver's door
continu- was open (or the driver's
door was opened while the
engine switch
ACCESSORY mode).
Correction procedure
Close all of the doors
and lock the
again.
switch was
ACCESSORY
Turn the engine switch
off and
driver's door.
was in
doors
close the