Lighting/Testing And Failure Procedure - Real Flame Elegance Series Installation & Operating Manual

LIGHTING MAIN BURNER
FOR YOUR SAFETY READ BEFORE LIGHTING
Before igniting the fire, check for gas leaks.
Use only the ignition components supplied.
Do not use this appliance if any part has been under water. Immediately call a qualified service
technician to inspect the appliance and replace any part of the control system and any gas control
that has been under water.
LIGHTING INSTRUCTIONS
1.
2.
TO TURN OFF GAS TO APPLIANCE
1. Turn off the remote wall switch.
TESTS TO BE CARRIED OUT BY INSTALLER
1. Carry out a smoke test to ensure the fireplace is drawing.
2. Test that the Test Point Pressures are correctly set.
3. Check that there are no gas leaks form any of the fittings.
4. Explain to the customer how the unit operates and how to turn it on and off.
FAILURE PROCEDURE
If when the wall switch is turned to the "ON" position and the fire fails to ignite, check the
following:
1. Ensure that the wiring terminals are not loose.
2. Test that the inlet and working pressures are both correct.
STOP! Read the safety information before proceeding.
Turn on the remote wall switch.
• If the fire will not stay lit after several tries turn the switch to "OFF" and call your service
technician or gas supplier.
13