Add More Crewcom Devices - Pliant Crewcom CCU-22 Operating Manual

Add More CrewCom Devices

If you need to add additional CrewCom devices (e.g., a Hub, RT, or additional Control Units) after you've applied your
CrewCom Configuration File, you'll need to do the following:
1. Add the device(s) to your system diagram in CrewWare, then save the Configuration File change and apply the
new Configuration File to your system. (Remember, you cannot make System Diagram changes while
CrewWare is "live.") (See the
"Upload Configuration File (CCF)" on page 32
2. Connect the additional CrewCom device(s) via an available CrewNet RJ-45 Copper or duplex LC Fiber port.
CrewWare Manual for information on building a system diagram , and see
for more information on that topic.)
Setup and Installation - 36