Flame & Temperature Adjustment; Flame Characteristics; Inspecting The Venting System - Majestic DVBR36 Homeowner's Installation And Operating Manual

Fig. 52 Place Left and Right Cover Logs and Center Log on grate.
Left Cross Log
Fig. 53 Place Left Front Log, Left Cross Log and Log Top Right.
Top logs must be placed properly onto
notches.
Turn
counterclockwise
to decrease
flame height
Fig. 54 Flame adjustment knob for Honeywell valve.
20000584
Left Cover Log
Log Top Right
(DVBR42 ONLY)
�����
���� ����
����
Left Front Log
�����
���� ����
����
Turn clockwise
to increase
flame height
HV102
Honeywell hi/lo knob
4/5/99 djt
DVBR Series Direct Vent Gas Fireplace
For fireplaces equipped with Hi/Lo valves,
flame adjustment is accomplished by rotating
the Hi/Lo adjustment knob located near the
centre of the gas control. (Fig. 54 & 55)
It is important to periodically perform a visual
check of the pilot and the burner flames.
Compare them to Figures 56, 57 & 58. If any
of the flames appear abnormal call a service
Right Cover
person.
Log
Center Log
This appliance venting system was designed
and constructed to develop a positive flow
LG391
adequate to remove flue gases to the outside
atmosphere.
Any foreign objects in the venting system,
except those designed specifically for the
venting system, may cause spillage of flue
gases.
To inspect the venting system, make sure the
main gas valve is off. Remove glass frame
(See Glass Frame Removal Section). Using
a flashlight, check the area above the baffle
in the combustion dome. Clean if necessary.
LG392
Turn
counterclockwise
to increase
flame height
Fig. 55 flame adjustment knob for SIT valve.
3/8" - 1/2"
HV102
Fig. 56 Correct pilot flame appearance.
Flame & Temperature Adjustment

Flame Characteristics

Inspecting the Venting System

FP390
FLAME ADJUSTMENT KNOB
11/21/96
Turn clockwise
to decrease
flame height
25