Optional Fk-12 Fan Hook-up
1. Remove control cover from unit.
2. Remove glass door by rotating latches at bottom
corners of door. Refer to Page 23.
3. Remove the 9 screws securing burner to combustion
bottom.
4. Remove burner by lifting up and rotating toward front
of unit.
5. Set burner aside.
6. Install FK-12 fan in back of unit between hearth sup-
ports. (Fig. 72)
7. Secure fan on velcro strips.
8. Plug fan into EB-1 receptacle.
9. Be sure fan motor does not touch hearth supports.
Any electrical re-wiring of this fan must be
completed by a qualified electrician.
Turn off all power before hook-up.
Cold Air Box
Hearth
See
Support
Detail
EB-1 Re-
ceptacle
Cold Air Box
Side View
Front of
Unit
Base Pan
Hearth Pan
Detail
Fig. 72 FK-12 Fan Kit placement.
20000584
584-10
Fan placement
DVBR Series
Optional Accessories
Top View
FK-12 Fan
A
Base Pan
Access Cover
Hearth Pan
FK-12 Fan
A
DVBR Series Direct Vent Gas Fireplace
Optional remote control units are available to control
different functions of the appliance.
Model Functions Controlled
RC1
RC2
IMTFK Wall mounted thermostat control
1. Remove glass and logs.
2. Insert supports under ceramic hearth panels.
(Fig. 73)
3. Remove three (3) screws securing heat shield to
combustion dome. (Fig. 74)
4. Place rear ceramic panel in back of unit. (Fig. 75)
5. Place side panels.
6. Replace heat shield, logs and glass.
Burner
Hearth
Support
Fig. 73 Ceramic support.
Heat Shield
Fig. 74 Heat shield.
584-10
Remote Controls
ON/OFF
ON/OFF and Temperature
Ceramic Refractory Panels
Ceramic Support
Grate
Hearth Panel
Section A
H101
Ceramic Panel Supports
3/16/99 djt
Front View
H103
heat shield
3/1/99 djt
H101
Heat Shield
(3) Screws
Side View
Section A
H103
35