Flame & Temperature Adjustment; Flame Characteristics - Majestic 33LDVT Installation Instructions And Homeowner's Manual

LDVT Series Direct Vent Gas Fireplace
43LDVT
1. Place rear log (BD15) on rear bracket (ensure log is
centered and seated properly to the log support).
2. Place front left log (BD16). Use log's bottom notch
to locate it onto the front support and just rest on
top of the burner housing assembly.
3. Place front right log (BD17). Use log's
bottom notch to locate it onto the front
support and just rest on top of the burner
housing assembly.
4. Place ember material on top of burner.
5. Scatter the ember material over the tiles
on the front area of the burner housing.
(Fig. 42) Do not pack the ember material.
Separate it when unpacked and keep it in
a fluffy and loose condition for a more real-
istic ember effect.
6. Place front center log (B138) on top of the
two small shelves at the front log support, and
between the left and right logs.
7. Place top center log (BD18) on top of the rear log
using the hole locator under the log and on top of
front right log.
8. Scatter lava rock material round the firebox base.
Do not place any of the lava rock material on the
burner housing assembly.
Flame & Temperature Adjustment
RN/RP & EN/EP Models
For units equipped with 'HI/LO' valves the flame adjustment
is accomplished by rotating the 'HI/LO' adjustments knob
located near the center of the gas control valve. (Fig.
43)
Turn
counterclockwise
to increase
flame height
Fig. 43 Flame adjustment knob for SIT valve.
FP390
FLAME ADJUSTMENT KNOB
11/21/96
26
Rear
(BD15)
Front
Left
(BD16)
Lava Rock
It is important to periodically perform a visual check of
the pilot and burner flames. Compare them to Figures 44
and 45.
If the flame patterns appear abnormal contact a qualified
service provider for service and adjustment.
Turn clockwise
to decrease
flame height
Fig. 44 Correct pilot flame appearance.
Top Center
(BBD18)
Figure 42
Front Center
(B138)

Flame Characteristics

Front Right
(BD17)
LG434
Lava
Rock
Ember Material
SIT RN/RP
SIT EN/EP, IN/IP
FP1541
10007852