Flame & Temperature Adjustment; Flame Characteristics - Majestic 33LDVR Installation Instructions And Homeowner's Manual

Builder rear vent direct vent
Table of Contents

Advertisement

43LDVR
1. Place rear log (BD15) on rear bracket (ensure log is
centered and seated properly to the log support).
2. Place front left log (BD16). Use log's bottom notch to
locate it onto the front support and just rest on top
of the burner housing tile.
3. Place front right log (BD17). Use log's bottom
notch to locate it onto the front support and
just rest on top of the burner housing.
4. Place ember material on top of burner.
5. Scatter the ember material over the tiles
on the front area of the burner housing.
(Fig. 46) Do not pack the ember material.
Separate it when unpacked and keep it in a
fluffy and loose condition for a more realistic
ember effect.
6. Place front center log (B138) on top of the
two small shelves at the front log support,
and between the left and right logs.
7. Place top center log (BD18) on top of the rear log
using the hole locator under the log and on top of
front right log.
8. Scatter lava rock material round the firebox base.
Do not place any of the lava rock material
on the burner housing assembly.
Flame & Temperature Adjustment
RN/RP & EN/EP Models
For units equipped with "HI/LO" valves the flame
adjustment is accomplished by rotating the "HI/LO"
adjustment knob located near the center of the gas
control valve. (Fig. 47)
SIT 820 Valve
Turn
counterclockwise
to increase
flame height
Fig. 47 Flame adjustment knob for SIT valve.
FP390
FLAME ADJUSTMENT KNOB
11/21/96
10007317
Rear
(BD15)
Front
Left
(BD16)
Turn clockwise
to decrease
flame height
LDVR Series Direct Vent Gas Fireplace
Figure 46
43LDVR
Top Center
(BBD18)
Lava Rock
Front Center
(B138)
�����

Flame Characteristics

����� ����
����
It is important to periodically perform a visual check
of the pilot and burner flames. Compare them to the
illustrations. (Figs. 48 & 49)
If the flame patterns appear abnormal contact a
qualified service provider for service and adjustment.
Fig. 48 Correct pilot flame appearance.
Front Right
(BD17)
LG434
Lava
Rock
Ember Material
SIT RN/RP
SIT EN/EP, IN/IP
FP1541
27

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

36ldvr39ldvr43ldvr

Table of Contents